Riser clamp
A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe.[1][2] The friction between the pipe and riser clamp transfers the weight of the pipe through the riser clamp to the building structure. Risers are generally located at floor penetrations, particularly for continuous floor slabs such as concrete.[3] They may also be located at some other interval as dictated by local building codes or at intermediate intervals to support plumbing which has been altered or repaired. Heavier piping types, such as cast iron, require more frequent support. Ordinarily, riser clamps are made of carbon steel and individually sized to fit certain pipe sizes.
There are at least two types of riser clamp: the two-bolt pipe clamp and the yoke clamp.[4]
References
- ^ "Riser Clamps". Warwick Hangar. Retrieved October 2, 2017.
Our Riser Clamp is used for the support of steel or cast iron pipe lines where extreme load conditions exist. The Riser Clamp utilizes the structure to support the legs on each end of clamp, normally rests on the floor through which the riser passes.
- ^ "FAQ: What is a riser clamp?". Piping Technology and Products, Inc. Retrieved October 2, 2017.
A riser clamp is a pipe clamp for the support of vertical pipelines, and they include separate load bolts, to transfer the piping load to the remainder of the pipe hanger assembly.
- ^ "Riser Clamps - Pipe Supports". BC Fasteners & Tools. Retrieved 2023-02-02.
- ^ "FAQ: What is the major benefit or reason for using a yoke pipe clamp as opposed to regular two bolt pipe clamp?". Piping Technology and Products, Inc. Retrieved October 2, 2017.
The main benefit is that the yoke clamp can support a greater amount of load. Additionally, the lower portion of the clamp does not significantly protrude beyond the pipe O.D. This is beneficial in installations where clearance is an issue.
- v
- t
- e
concepts
- Air gap (plumbing)
- Backflow
- Compatibility (chemical)
- Corrosion
- Drain (plumbing)
- Drinking water
- Fuel gas
- Friction loss
- Grade (slope)
- Greywater
- Heat trap
- Hydrostatic loop
- Leak
- Neutral axis
- Onsite sewage facility
- Pressure
- Sanitary sewer
- Sewer gas
- Sewage
- Sewerage
- Siphon
- Storm sewer
- Stormwater
- Surface tension
- Tap water
- Thermal expansion
- Thermal insulation
- Thermosiphon
- Trap (plumbing)
- Venturi effect
- Wastewater
- Water hammer
- Water supply network
- Water table
- Well
- Brazing
- British Standard Pipe (BSP)
- Cast iron pipe
- Chemical drain cleaners
- Compression fitting
- Copper tubing
- Crimp (joining)
- Drain-waste-vent system
- Ductile iron pipe
- Flare fitting
- Garden Hose Thread (GHT)
- Gasket
- Hydronics
- Leak detection
- National Pipe Thread (NPT)
- Nominal Pipe Size (NPS)
- O-ring
- Oakum
- Pipe (fluid conveyance)
- Pipe dope
- Pipe support
- Plastic pipework
- Push-to-pull compression fittings
- Putty
- Sealant
- Sewage pumping
- Soldering
- Solvent welding
- Swaging
- Thread seal tape
- Threaded pipe
- Tube bending
- Water heat recycling
- Atmospheric vacuum breaker
- Automatic bleeding valve
- Automatic faucet
- Backflow prevention device
- Ball valve
- Bleed screw
- Booster pump
- Butterfly valve
- Check valve
- Chemigation valve
- Chopper pump
- Circulator pump
- Cistern
- Closet flange
- Concentric reducer
- Condensate pump
- Coupling (piping)
- Diaphragm valve
- Dielectric union
- Double check valve
- Eccentric reducer
- Expansion tank
- Faucet aerator
- Float switch
- Float valve
- Floor drain
- Flow limiter
- Flushing trough
- Flushometer
- Gate valve
- Globe valve
- Grease trap
- Grinder pump
- Hose coupling
- Manifold
- Needle valve
- Nipple (plumbing)
- Pinch valve
- Piping and plumbing fitting
- Plug (sanitation)
- Pressure regulator
- Pressure vacuum breaker
- Pressure-balanced valve
- Pump
- Radiator (heating)
- Reduced pressure zone device
- Reducer
- Relief valve
- Riser clamp
- Rooftop water tower
- Safety valve
- Sewage pump
- Street elbow
- Submersible pump
- Tap (valve)
- Thermostatic mixing valve
- Trench drain
- Vacuum breaker
- Vacuum ejector
- Valve
- Water tank
- Zone valve
- Accessible bathtub
- Bathtub
- Bidet
- Dehumidifier
- Dishwasher
- Drinking fountain
- Electric water boiler
- Evaporative cooler
- Flush toilet
- Garbage disposal unit
- Hot water storage tank
- Humidifier
- Icemaker
- Instant hot water dispenser
- Laundry tub
- Shower
- Sink
- Storage water heater
- Sump pump
- Tankless water heater
- Urinal
- Washing machine
- Washlet
- Water dispenser
- Water filter
- Water heater
- Water softener
and control
trades,
and services
organizations
and standards
- Fire sprinkler system
- Piping
- Template:HVAC
- Template:Public health
- Template:Sewerage
- Template:Toilets
- Template:Wastewater